3 Tips for maintaining your clipper blades

Maintaining the clipper blade can seem like a daunting task at first. You are going to discover 3 simple and easy to use tips to keep your blades in good condition and increase their lifespan.

Clipper blade maintenance .

Grooming clippers have an average SPM (Strokes Per Minute) of about 3000, which means the blade makes about 3000 strokes in one minute when mowing. These 3000 rubs will cause your blades to heat up, over the long term, this heating can damage your blades in several ways, reduce their lifespan and create an unpleasant feeling in the groomed animal due to the heat of the blade. Proper maintenance of your blades will improve cut quality and reduce how often you need to sharpen them. Here are 3 tips to improve the life of your blades.

# 1) Oil your blade

Applying oil to your blade is an essential step that should not be neglected. One of the main causes of a dull blade is lack of oil. A well-oiled blade could save you a sharpening or two! To begin with, the oil should be applied before you even start your mowing, then, a regular application at intervals of about 10 minutes, depending on the speed of your mower and the model of blade used and finally, a final oiling of your blade after cleaning it when you are done.

How to apply the oil to your blade? It’s very simple. Administer 1 drop of oil to each corner of the knife of your blade, after applying the oil start your mower for a few seconds to spread the oil evenly over your blade. Wipe off excess oil to prevent the build-up of dirt, hair or dust.

Following these steps while mowing will keep your blade in good condition and also improve the cut quality of your blade.

# 2) Cool your blade

Cooling your blade is as important a step as applying oil to your blade. As mentioned earlier, your blades will get hot from the friction of the knife, cooling your blade will greatly reduce this heat and thus make the mowing more pleasant when the blade comes into contact with the animal. Raising the temperature also increases the malleability of the metal in your blade. This can cause minimal deformation of the knife and therefore the sharpening of the blade.

To properly apply a cooler, the protocol is similar to applying oil. However, the cooler should be applied only during mowing and not before and after, a regular application at approximately 10 minute intervals, depending on the speed of your mower and the model of blade used. Remember to dry your blade thoroughly at the end of mowing to remove all moisture.

# 3 cleaning for maintenance of the clipper blade

Finally, nothing beats a good cleaning of your blade after each use. Usually, when purchasing a mower, a small cleaning brush is provided. If you don’t have a brush, an old toothbrush can do the job. Take the time to thoroughly clean your blade after each use with your brush, this little 5 minutes of cleaning will allow your blade not to accumulate hair and dirt, and then to wear less quickly.

Conclusion

In conclusion, the 3 tips presented earlier are a very good habit to take. Applying oil, cooler and cleaning your blade will save you blade life and also improve cut quality. To learn more about clippers or grooming clippers , visit this page. If you want to get these products for the maintenance of blades clipper , visit this page.